Lifting clamps for safe transportation of steel plates in horizontal position. For hoisting steel plates up to hardness 37 RC (345 HB).

HSL low profile lifting table with ramp available in 1 and 2 ton versions Made in The Netherlands, designed following EN12100-1/2, EN1570-1 norms

REMA Geared Trolley 117, UP to 30 Tons, Beam Width 124-305, Operating height 3 meters. Marking: According to standard, CE-marked. Standard: EN 12100, EN 13157

REMA CNMA Vertical Non-Marking Lifting Clamp Up To 0.5 tons Jaw opening adjustable in steps of 20 mm from 3 to 180 mm. For hoisting and transporting of stainless steel, aluminum, wood and natural stone where the workpiece can not be damaged. Marking: Acc

REMA Block Lifting Clamps CBKN, Up To 3 tons . 2 Special Synthetic Anti-Friction Pads to guarantee non-marking. Marking: According to standard, CE-marked Standard: EN 13155, EN 12100
Warning: The surface roughness of the material to be hoisted must have

High quality Dynamometer 04 excellent resolution from 1.25 Tom up to 20Ton made of anodized Alu housing with IP65 Test load 2 x WLL Safety factor 5 x WLL Alkaline battery (9V type). Battery operating time about 100 hours.

REMA RMBCV with adjustable jaws is an adjustable spindle beam clamp that grips the flange of the beam in an optimal way.

Adjustable spindle beam clamp for establishing a semi-permanent suspension point on angle steels.

These low headroom hoist-trolley combinations are only supplied with Rema® Select 200OD hand chain hoist.

For use as a (temporary) lifting point in spaces with HP- (bulb) profiles, like sectional ship parts and ship engine rooms.